Avaya IP 600 Configuration Note page 21

UCC / Avaya one-X Speech - Avaya IP 600 / G3 / S8700 / S8300 E1 QSIG
8.4 When configuring remote users, ensure that the tie trunks between
PBXs pass ALL 10-digits of Calling Party Information. If a QSIG digital
tie trunk is used between PBXs, ensure that QSIG Value-Added and
Name in the trunk group (use command:
"n," and Coverage of Calls Redirected off-Net Enabled (use command:
change system-parameters
Revision Issue Date
Version A 08/25/03
Version B 10/09/03
Version C 02/16/04
Version D 06/28/04
Version E 08/18/04
Version F 09/02/04
Version G 10/18/04
Version H 12/1/04
Version I 03/03/08
Version J 05/16/08
Version K 02/16/09
©2009 AVAYA Inc. All rights reserved. All trademarks identified by the ®, SM and TM are registered trademarks,
service marks or trademarks respectively. All other trademarks are properties of their respective owners. The above
information is based on knowledge available at the time of publication and is subject to change without notice. Printed
in U.S.A.
AVAYA
1033 Murphy Blvd.
Milpitas, CA 95035
(408) 577-7000
http://www.avaya.com
The above information is provided by AVAYA Inc. as a guideline. See disclaimer on page 1
change trunk-group
coverage-forwarding) is set to "y."
CHANGE HISTORY
Reason for Change
Initial release
Added consideration 8.6 for sites with MM as voice mail and
9.5 patch information (PBX Software requirements)
Name change from ASA to UCC Speech Access
Added consideration 8.6 and changed values as mentioned in
same. Also added NMS card span config diagram at end
Section 3.1
Changed Consideration 8.6 from specifying MM to any QSIG
or IP Now integrated voice messaging system.
Merge and cleaned up considerations for clarity.
Added info regarding setting Send Name to N in
consideration 8.4.
Updated consideration 8.3 to indicate it applies to MM voice
systems using IP Now or QSIG integration.
Updated Section 1.0 with new AG4040 board information and
added footnote regarding AG4000 v. AG4040 differences.
Product Name change. UCC to UCC / Avaya one-X Speech
Updated information to show support of CG6060 board and
added notes about AAR and use of "*" in consideration 8.3
Updated for one-X Speech 5.0 release. Also updated PBX
Circuit Pack and Media Module vintages to reflect minimum
version (firmware) required.
21
C o n f i d e n t i a l
Send
xx) are set to