Avaya IP 600 Configuration Note page 20

UCC / Avaya one-X Speech - Avaya IP 600 / G3 / S8700 / S8300 E1 QSIG
8.2
UCC / AVAYA one-X Speech must be administered on the switch as
the first coverage point after the primary destination, (e.g. the user's
desk phone), and the user's voicemail as the second coverage point to
support the "Find Me" feature. The switch will pass to UCC / AVAYA
one-X Speech calling number (i.e. ANI) and redirect number (i.e.
original called number). Since the switch call coverage path has been
changed to include UCC / AVAYA one-X Speech as the first coverage
point after the primary destination, if a subscriber has his extension in
a Send All Calls/Do-Not-Disturb mode, the call will go to UCC /
AVAYA one-X Speech. UCC / AVAYA one-X Speech will attempt to
find the subscriber although his extension is in a Send All Calls/Do-Not-
Disturb mode. To prevent this, and achieve equivalent Send All
Calls/Do-Not-Disturb functionality, the UCC / AVAYA one-X Speech
subscriber must use the UCC / AVAYA one-X Speech "Hold My Calls"
voice command or turn on the GUI Web "Do-Not-Disturb" option.
8.3
If an MM Voicemail system is integrated to the Avaya PBX using QSIG
or AVAYA H.323 IP integration, you must administer a dialing rule for
the Voice Mail pilot number in the UCC / AVAYA one-X Speech "Number
Translation Parameters" dialog by entering the "Routing Digits (AAR/ARS
Access Code)" and the "Voice Mail Number" configured for the MM Hunt
Group (Pilot Number) on the switch as the dialed digits for a Private
Number rule for the MM Voicemail pilot number. Also, create an ANI
Substitution Table for this dialing rule to change the MM Voicemail pilot
number to blank. As an example, if the pilot number for an MM QSIG or
IP integration voicemail system is 51234, the AAR access code is 100, and
the Voice Mail Number is 5551234, the following Private dialing rule
should be created:
Number
51234
Finally, enter the pilot number (51234) in the UCC / AVAYA one-X Speech
Voice Mail Setup Screen for the associated MM QSIG or IP integrated
system.
Note: Failure to follow the above steps for all MM QSIG or IP
integrated Voicemail systems will result in a failed transfer to
the Voice Mail System and the caller will only hear silence.
Important: Use of the leading character "
UCC 2.1, or one-X Speech 4.0 or higher is installed.
The above information is provided by AVAYA Inc. as a guideline. See disclaimer on page 1
Dial ANI Template
1005551234 51234
*
" is not supported unless SP1 for
20
C o n f i d e n t i a l
ANI Substitution
[BLANK]