Install The Booth Control - Graco ProMix PD2K Installation Manual

Install the Booth Control

Install the Booth Control
1. Use screws (S) to mount the bracket (10) for the
Booth Control (13) on the wall. Connect a ground
wire (G) to one of the screws. Connect the other
end of the ground wire to a true earth ground.
Figure 14 Ground the Booth Control Bracket
28
2. Snap the Booth Control into the bracket.
3. Connect the Booth Control to the Isolation Board
in the Electrical Control Box, using the 50 ft (15.2
m) intrinsically safe CAN cable (163).
NOTE: For a list of alternate cable lengths, see
Electrical Schematics, page
of cable used in the hazardous location must not
exceed 120 ft (36 m). The total length of all cable
used in the system must not exceed 150 ft (45 m).
Figure 15 Install the Booth Control
41. The total length
332457H