Install The Display Module - Graco ProMix PD2K Installation Manual

Install the Display Module

1. Use the screws (11) to mount the bracket (10) for
the Advanced Display Module (12) on the front of
the Control Box or on the wall, as you prefer.
2. Snap the Advanced Display Module into the
bracket.
Figure 12 Install Display Module
3. Connect one end of the 5 ft (1.5 m) CAN cable
(provided) to the Advanced Display Module
(M). The other end of the cable comes from the
factory connected to the Enhanced Fluid Control
Module (EFCM).
NOTE: For a list of alternate cable lengths, see
Electrical Schematics, page
all cable used in the system must not exceed 150
ft (45 m).
332457H
41. The total length of
Install the Display Module
Figure 13 Advanced Display Module Connection
Ports
Item Description
J Battery Cover
K Model Number
L
USB Drive Interface
M CAN Cable Connection
N ADM Status LEDs
P Accessory Cable Connection
R Token Access Cover
27