Setup
Operating Instructions 969 PURE - 00.0 - 04/2020
6.4.3
Assembling the standard tabletop
Fig. 29: Assembling the standard tabletop
①
②
(1) - Foot button
(2) - Stand
(3) - Setpoint device
To assemble the standard tabletop:
1.
Place the stand (2) on the tabletop as shown above.
2.
Screw the stand (2) into the previously drilled holes.
3.
Screw the foot button (1) in as close to the left bar of
the stand's cross member as possible.
4.
Press the lugs at the end of the pull rod (4) onto the round
pin of the setpoint device (3) and the pedal (5).
5.
Tighten the pedal (5).
(4) - Pull rod
(5) - Pedal
⑤
④
③
57