Setup
Operating Instructions 969 PURE - 00.0 - 04/2020
6.4
Tabletop
Ensure that the tabletop has sufficient load-bearing capacity
and strength. If you want to make your own tabletop, use the
dimensions given in the diagram in the Appendix ( p. 79) as
a template.
6.4.1
Completing the standard tabletop
Fig. 27: Completing the standard tabletop
①
②
③
④
(1) - Setpoint device
(2) - Tabletop brace
(3) - Drawer
(4) - Tabletop
(5) - Hole for the stand
To complete the standard tabletop:
1.
Turn the tabletop over so that the underside is facing up.
2.
Assemble all components to the underside of the tabletop as
shown above.
3.
Secure all components using the strain relief mechanism (10).
4.
Use cable clamps (11) to attach the connecting cable to
the underside of the tabletop.
5.
Drill the holes for the stand (7) as provided in the drawing.
⑤
(6) - Cable duct
(7) - Reservoir for used oil
(8) - Strain relief mechanism
(9) - DAC control
⑨
⑧
⑦
⑥
55