Ricoh Ri 100 Manual page 114

2. Differences Related to Parts Replacement
1. Press the [ /Menu] key.
2. Press the [ ] or [ /Menu] key to display [Maintenance], and then press the [#Enter] key.
3. Press the [ ] or [ /Menu] key to display [Height Adjust], and then press the [#Enter] key.
4. Press the [#Enter] key.
5. Press the [ ] or [ /Menu] key to enter the height value, and then press the [#Enter] key.
• You can enter a height value from -20 to 20 in increments of 0.1. We recommend changing
the existing setting by entering values in increments of ±0.1 to 0.3.
• If the printed image is blurry when the A4 standard tray or A5 tray is used, first enter "-2.0" as
the height value, and then increase the value in increments of 0.1 to 0.3 until the error
message is not displayed. While adjusting the height, load the fabric into the cassette so that
the printing surface can be flat.
• If you enter a negative value as the height value and the value is too small, the machine might
not start printing because the height position sensor in the machine reacts. Adjust the height of
the cassette by pressing the [Adjust Height ] or the [Adjust Height ] key.
• The value you set in Step 5 remains after the machine is turned off.
• If you enter "-2.0"as the height value and want to increase the value in Step 5, press the [Stop] key
to cancel printing whenever you enter a new height value.
112
EN