Transport With A Crane; Using Lifting Rods - Siemens SINAMICS SM150 Operating Instructions Manual

Preparations for use
4.3 Transportation
4.3.5

Transport with a crane

Danger due to incorrect transport
If the transport unit is not properly transported with a crane, the transport unit/cabinet could fall
or tip over This can result in death, serious injury or material damage.
● Carefully comply with the safety instructions relevant for transport.
● Carefully observe the information regarding the center of gravity on the transport unit.
Danger due to unsuitable cross-arms
If inappropriate cross-arms are used, the transport unit or cabinet can tip over. This can result
in death, serious injury or material damage.
● Observe the specifications provided in DIN EN 13155 on cross-arms.
Observe the following points for safe transport:
● When using a crane to transport the equipment, keep to the permissible lifting capacity. Pay
● If the cabinet center of gravity is off-center, use suitable lifting equipment, e.g. a lifting beam.
● If the cabinet has eye hooks, use them. In such cases, do not use any lifting rods.
4.3.6

Using lifting rods

During transportation with a crane, force is absorbed by the supporting frame of the cabinet.
The supporting frame remains on the unit. The device is mounted at the installation site via the
supporting frame.
Note
Transporting the option cabinet
When transporting an option cabinet, the force is absorbed via the screwed-on U sections.
Remove the U sections after transporting the cabinet.
Please observe the transport information in the option cabinet.
Note
Lifting bars
The lifting bars are not included in the scope of delivery.
50
WARNING
WARNING
attention to the center of gravity position.
SINAMICS SM150 6SL3845-7NN42-2AA3 HBIS Shigang WRM NTM
Operating Instructions Rev.202003051222 3005356504