C3 Servomanager - Parker Compax3S Series Installation Manual

Notes on the Documents Supplied
1.1

C3 ServoManager

Installation of the C3
ServoManager
Connection between
PC and Compax3
Device Selection
Configuration
4
The Compax3 ServoManager can be installed directly from the Compax3 DVD.
Click on the corresponding hyperlink resp. start the installation program
"C3Mgr_Setup_V.....exe" and follow the instructions.
PC requirements
Recommendation:
Operating system: MS Windows XP SP3 / MS Vista (32 Bit) / Windows 7 (32 Bit / 64 Bit)
Browser: MS Internet Explorer 8.x or higher
Processor: Intel / AMD Multi core processor >=2GHz
RAM memory: >= 1024MB
Hard disk: >= 20GB available memory
Drive: DVD drive (for installation)
Monitor: Resolution 1024x768 or higher
Graphics card: on onboard graphics (for performance reasons)
Interface: USB 2.0
Minimum requirements:
Operating system: MS Windows XP SP2 / MS Windows 2000 as from SP4
Browser: MS Internet Explorer 6.x
Processor: >=1.5GHz
RAM memory: 512MB
Hard disk: 10GB available memory
Drive: DVD drive
Monitor: Resolution 1024x768 or higher
Graphics card: on onboard graphics (for performance reasons)
Interface: USB
Note:
For the installation of the software you need administrator authorization on the

target computer.
Several applications running in parallel, reduce the performance and operability.

Especially customer applications, exchanging standard system components

(drivers) in order to improve their own performance, may have a strong influence
on the communication performance or even render normal use impossible.
Operation under virtual machines such as Vware Workstation 6/ MS Virtual PC is

not possible.
Onboard graphics card solutions reduce the system performance by up to 20% and

cannot be recommended.
Operation with notebooks in current-saving mode may lead, in individual cases, to

communication problems.
Your PC is connected with Compax3 via a RS232 cable (SSK1).
Start the Compax3 ServoManager and make the setting for the selected interface in
the "Options Communication settings RS232/RS485..." menu.
In the menu tree under device selection you can read the device type of the
connected device (Online Device Identification) or select a device type (Device
Selection Wizard).
Then you can double click on "Configuration" to start the configuration wizard. The
wizard will lead you through all input windows of the configuration.
192-120102 N19 June 2014
Single axis devices