Conditions Of Utilization For Ul Certification Compax3S - Parker Compax3S Series Installation Manual

Introduction
2.7.2.

Conditions of utilization for UL certification Compax3S

14
UL certification for Compax3S
conform to UL:
Certified
The UL certification is documented by a "UL" logo on the device
(type specification plate).
Conditions of utilization
The devices are only to be installed in a degree of contamination 2 environment

(maximum).
The devices must be appropriately protected (e.g. by a switching cabinet).

The X2 terminals are not suitable for field wiring.

Tightening torque of the field wiring terminals ( green Phoenix plugs)

C3S0xxV2

C3S1xxV2,

C3S0xxV4, C3S150V4
C3S300V4

Temperature rating of field installed conductors shall be at least 60°C. Use copper

lines only
Please use the cables described in the accessories chapter, they feature a
temperature rating of at least 60°C.
Maximum Surrounding Air Temperature: 45°C.

Motor over temperature monitoring is only supported, if the external temperature

sensor is connected.
Suitable for use on a circuit capable of delivering at least 5000 symmetrical

amperes effectively and 480 Volts when protected with fuses.
Fuses:
In addition to the main fuse, the devices must be equipped with a S201K, S203K,
S271K or S273K circuit breaker with K characteristic made by ABB.
C3S025V2: ABB, nom 480V 10A, 6kA

C3S063V2: ABB, nom 480V, 16A, 6kA

C3S100V2: ABB, nom 480V, 16A, 6kA

C3S150V2: ABB, nom 480V, 20A, 6kA

C3S015V4: ABB, nom 480V, 6A, 6kA

C3S038V4: ABB, nom 480V, 10A, 6kA

C3S075V4: ABB, nom 480V, 16A, 6kA

C3S150V4: ABB, nom 480V, 20A, 6kA

C3S300V4: ABB, nom 480V, 25A, 6kA

CAUTION
Risk of electric shock.
Discharge time of the bus capacitor is 10 minutes.
The drive provides internal motor overload protection.

This must be set so that 200% of the motor nominal current are not exceeded.
Cable cross-sections

Mains input: corresponding to the recommended fuses.

Motor cable: corresponding to the Nominal output currents (see on page 39)

Maximum cross-section limited by the terminals mm

C3S0xxV2

C3S1xxV2,

C3S0xxV4, C3S150V4
C3S300V4

192-120102 N19 June 2014
Single axis devices
according to UL508C

E-File_No.: E235342

"UL" logo:
0.57 - 0.79Nm
0.57 - 0.79Nm
1.25 - 1.7Nm
2
/ AWG
2
2.5mm AWG 12
2
4.0mm AWG 10
2
6.0mm AWG 7
5 - 7Lb.in
5 - 7Lb.in
11 - 15Lb.in