Table of Contents
Advertisement
4. Select Specify an IP Address. In the
5. In the
6. Select the
7. Click Add.
8. Select the DNS Configuration tab, and verify the following
9. When finished, click OK to close the
10. Click OK again to close the
11. Click Yes in the dialog that appears to restart the computer.
Appendix A • Configuring Windows network settings manually for static IP address
an address from the range of available IP addresses listed in
the System Control Center FAQ page.
field, enter the address from the LAN1
Subnet Mask
Subnet Mask that you recorded from the System Information
page.
tab. In the
Gateway
LAN1 IP Address that you recorded from the System
Information page. See Figure 62.
Figure 62: Entering the remote terminal's IP address
settings:
a. Make sure
Enable DNS
b. The
Domain Name
c. Under DNS Server Search Order, you should see
. If you do not, type it in the box and click
66.82.4.8
Add. This is your primary DNS server.
d. For your secondary DNS server, enter
e. Delete all other DNS addresses.
IP Address
New Gateway
is selected.
should be
direcpc.com
66.82.4.12.
TCP/IP Properties
dialog box.
Network
1037076-0001 Revision C
field, enter
field, enter the
.
box.
69
Advertisement
Table of Contents
