Local Area Connection Properties - Hughes HN7000S Manual

Upgrading to a remote terminal

Hide thumbs Also See for HN7000S:

Table of Contents

Appendix A • Configuring Windows network settings manually for static IP address

1037076-0001 Revision C

4. Ensure that the Client for Microsoft Networks and Internet

Protocol (TCP/IP) are installed and checked. If NetBEUI

appears in the list, uninstall it.

5. Highlight

Internet Protocol (TCP/IP)

uncheck the check box, and click Properties to access the

Internet Protocol (TCP/IP) Properties screen. See Figure 58.

Figure 58: Local Area Connection Properties

6. In the General tab, select Use the following IP address. Enter

an appropriate IP Address from the range of available IP

addresses listed in the FAQs in the System Control Center.

7. In the

Subnet Mask

Subnet Mask that you recorded from the System Information

page.

8. In the

Default Gateway

you recorded from the System Information page.

, being careful not to

field, enter the address from the LAN1

field, enter the LAN1 IP Address that

Table of Contents