Xerox 8850 Service Manual page 323

16. (Figure 2): Raise the image module and engage the developer module shipping brackets.
1
Loosen screw
4
Repeat steps 1 through 3
on other side
Figure 2 Engaging the Shipping Brackets
8850/ 510DP
17.
2
Slide bracket onto the shaft
3
Retighten screw
18. Remove the Charge Scorotron Assembly
19. Remove the Heat Rods
03/2003
6-37
(Figure 3): Install the shipping pads.
Image Module at Service Position
Figure 3 Installing the Shipping Pads
and place it in a Roll Media Supply Drawer.
(REP 10.1).
a. Wrap in bubble pack.
b. Tape cardboard to the entire length.
c. Place in a Roll Media Supply Drawer.
d. Secure the Roll Media Supply Drawer with tape
1
Install the shipping pads, one on
each end of the photoreceptor
2
Install the
foam pads,
one on each
side of the
top cover
(REP 9.8), wrap the assembly in bubble pack,
General Procedures
Removal Procedure