Xerox 8850 Service Manual page 107

7. (Figure 4): Remove the Media Transport Module from the Printer.
4
3
Lift the Media Transport Assem-
Rotate the Media Transport Assembly as shown to
bly out of the Printer and place
clear the assembly of its mounting hardware at
on a clean, flat surface
either end
1
Ensure that the tension on the Shaft
Release Pin has been released (Fig-
ure 1)
Figure 4 Removing the Media Transport Module
8850/ 510DP
2
Disengage the shaft from the retaining
slot at the rear of Printer frame by pull-
ing this end of Media Transport
Assembly out first
Replacement
Ensure that the Top Cover and the Image Module of the Printer are in the raised position prior
to beginning this replacement procedure.
NOTE: In the following steps, the terms "Left" and "Right" describe machine locations as
observed from the Roll Media Supply Drawer side of the Printer.
1. Set the Media Transport Module back onto the floor plate of the printer.
2. (Figure 5): Align the right side of the Media Transport Module Shaft with the spring-loaded
Shaft Release Pin. Reinstall the Media Transport Module
3
As the Shaft Release Pin is compressed, swing the left side of the Media
Transport Module Shaft inward, and into the retaining slot in left side of the
Printer frame
Shaft Release Pin
Media Transport
Module Shaft
1
Align Media Transport Module
Shaft with spring-loaded Shaft
Release Pin
Figure 5 Reinstalling the Media Transport Module
3. (Figure 3): Reattach the connectors on the left side of the Media Transport Module.
4. Reinstall the Fuser Drive Gear.
03/2003
4-31
CAUTION
2
Press the Media Transport Module
Shaft into the Shaft Release Pin,
compressing it
Repairs and Adjustments
REP 8.2