Xerox 8850 Service Manual page 170

Replacement
Do not rotate the Auger Gears individually more than the slight amount required for removal or
to mesh the teeth during reinstallation. If the factory setting of the augers is changed during the
procedure, perform ADJ 9.6 Augers.
NOTE: The gears must be reinstalled with the flanges as shown in order to ensure that all the
gears are secured.
1. (Figure 2): Reinstall the Pressure Equalizer Tubes.
1
Reinstall the Pressure
Equalizer Tube
4
Reinstall the gear
and the Grip Ring
2. Reinstall the Developer Module (REP
Repairs and Adjustments
REP 9.18
CAUTION
Flanges
2
Reinstall the
gear
3
Reinstall the
gear
Figure 2 Reinstalling the Pressure Equalizer Tubes
9.5).
6
Reinstall the Pres-
sure Equalizer Tube
Retainer
03/2003
4-94
7
Reinstall the screw
5
Reinstall the Pres-
sure Equalizer Tube
8850/ 510DP