Cable Routing For Active Line Connection Modules - Siemens SINAMICS S120 Manual

Electrical installation
4.5 Connections
1. Route the DRIVE-CLiQ/signal cable to the Control Unit into the cabinet from the bottom
left.
2. Use cable ties to secure the cable at suitable points.
3. Route the cable further in the cabinet to the upper side of the Control Unit. When doing
so, route the cable in a similar manner to the standard cables that have already been
installed in the cabinet.
4. Use cable ties to secure the cable at suitable points.
5. Connect DRIVE-CLiQ/signal cable to the Control Unit.
6. Route the DRIVE-CLiQ/signal cable to the Basic Line Module from the bottom left into the
cabinet.
7. Use cable ties to secure the cable at suitable points.
8. Route the cable further in the cabinet to the upper side of the Basic Line Module. When
doing so, route the cable in a similar manner to the standard cables that have already
been installed in the cabinet.
9. Use cable ties to secure the cable at suitable points.
10.Connect the signal cable at terminal block -X9.
11.Route the DRIVE-CLiQ cable through the cable bushing from the top into the Basic Line
Module, continue to the DRIVE-CLiQ connection -X400, -X401, -X402 and connect there.
4.5.11.3

Cable routing for Active Line Connection Modules

For the Active Line Modules, the customer must carry out the following cabling or connection
work:
Table 4- 12
Cable routing
Cable for the line supply (L1, L2, L3, PE)
Signal cables to terminals -X30, -X40, -X50
PROFIBUS cable or PROFINET cable to the Control Unit
DRIVE-CLiQ connections / signal cables to the Control Unit and to the Active Line
Module
Note:
The "Basic rules for cable routing" and "Preparatory steps" described above must
be observed whenever any cabling or connection work is performed!
100
Checklist for cabling or connection work for Active Line Modules
Completed?
Cabinet Modules liquid cooled
Manual, 10/2015, A5E37067587A