Opening/Closing The Printer Block - Toshiba TEC B-SX4T Series Maintenance Manual

3. NOTE FOR OPTIONAL EQUIPMENT INSTALLATION/MAJOR UNIT REPLACEMENT
/MAINTENANCE
In case of RFID-ready printers, disconnect the fan motor harness from CN19 on the Main PC
board, and then separate the side panel (L).
Side Panel (L)

3.3 OPENING/CLOSING THE PRINTER BLOCK

1) Open the top cover.
2) Turn the head lever counterclockwise to Free position.
3) Open the ribbon shaft holder plate.
4) Raise the print head block until it stops.
Stopper
NOTE: DO NOT excessively push down the print head block to close it. Dosing so may cause a
failure of the print head block or damage to the print head.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Fan Motor
Head Lever
Free position
Lock position (Label)
Lock position (Tag)
3.3 OPENING/CLOSING THE PRINTER BLOCK
CN19
Main PC Board
Ribbon Shaft Holder Plate
3- 4
EO18-33012B
Fan Motor Harness
Print Head Block