Power On Utilities; Printer Bios Update; Printer Initialization - Toshiba B-SV4D Series Manual

Thermal printer

Hide thumbs Also See for B-SV4D Series:

Table of Contents

5. POWER ON UTILITIES

There are three power-on utilities to set up and test B-SV4D hardware. These utilities are

activated by pressing FEED button and turning on the printer power simultaneously. The

utilities are listed as below:

3. Gap/Black Mark Sensor Calibration

4. Printer Self-Test & Dump Mode

5.1 Printer BIOS Update

If printer BIOS update is required, please follow the steps as below.

1. Turn off printer power.

2. Press FEED button while turning on the printer power. The LED will be indicated in

orange color first then will change to green and then red color.

3. Release FEED button and press it again immediately. The LED will change to orange

color and blinking then printer is in BIOS update mode.

4. Copy the BIOS FILE to printer parallel port by the following command is MS-DOS

prompt mode.

C:\>COPY BSV4D100.NEW /B LPT1

C:\>

NOTE: Underlined part differs depending on the ROM version.

5. The LED will change to green color and blink at one second interval.

When BIOS update is completed, printer will reset automatically.

5.2 Printer Initialization

Printer Initialization will restore printer settings to defaults.

Please follow the steps below to initiate the printer settings.

Turn off printer power.

Press FEED button while turning on the printer power. The LED will be indicated in orange color

first then will change to green and then red color.

Do not release the button until the LED is blinking in turn with orange and green color.

After initialization, printer will reset automatically.

5- 1

EO18-33013

5.1 Printer BIOS Update

Table of Contents