Applicable Model; Packing List - Toshiba TEC B-SX4T Series Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

4.22.1 Applicable Model

(1) This optional device is intended for the following models:
B-SX4T-GS20-QM-R and B-SX5T-TS22-QM-R, RFID ready printer.
An RFID Ready printer can be identified by the model name sticker on the front of the printer.
Be careful not to install this product in the B-SX4T-GS10-QQ/QQ-US and B-SX5T-TS10-QQ/QQ-
US RFID Ready printers.
(2) To use this device, printer firmware V4.5 or greater is required. Upgrade the firmware to V4.5 or
greater, if necessary. For the downloading procedure, refer to the B-SX4T/SX5T Series Maintenance
Manual.
Note that a RAM clear needs to be performed after downloading, so print out the maintenance
counter and parameter settings prior to downloading. After performing a RAM clear, restore the
printer parameter settings to the former states.
(3) The countries where the use of this device is allowed are as follows:
Model Name
B-SX704-RFID–U2-EU-R

4.22.2 Packing List

If any part is missing, please contact your TOSHIBA TEC sales agent.
• Antenna Ass'y (1 pc.)
• Bush (1 pc.)
• Antenna Cable (1 pc.)
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Frequency Band
UHF 869.7 to 870.0MHz
(Center frequency: 869.85MHz)
•RFID R/W Module (1 pc.)
• Cable Clamp (1 pc.)
• Installation Manual
(1 copy)
4-128
4.22 RFID MODULE (B-SX704-RFID-U2-EU-R)
Applicable Countries
EU member states and EFTA member states
• Antenna Frame
•Interface Cable (1 pc.)
EO18-33012B
(Revision Date Apr. 24, 2008)
• Ribbon Guide (1 pc.)
• Double Sems Screw
SMW-3x6 (5 pcs.)