Convenient Rds Functions; Selecting The Waveband/Memory Bank - Blaupunkt BRISBANE SD48 7 648 000 310 Operating And Installation Instructions

Radio mode

Convenient RDS functions

This device is equipped with an RDS (Radio
Data System) radio receiver. Many FM sta-
tions broadcast a signal that not only car-
ries the programme but also additional
information such as the station name and
programme type (PTY).
The station name appears on the display as
soon as the tuner receives it.
The convenient
(Alternative Frequency) and REGIONAL ex-
tend your radio's range of functions.
• AF: If the RDS function is activated, the
radio automatically tunes into the best
receivable frequency for the station
that is currently set.
• REGIONAL: At certain times, some ra-
dio stations divide their programme
into regional programmes providing
different content. You can use the REG
function to prevent the car radio from
switching to alternative frequencies
that are transmitting different pro-
gramme content.
Note:
REGIONAL must be activated/deacti-
vated (REG ON/OFF) separately in the
menu.
Switching the RDS function on/off
If you want to use the RDS functions (AF
and REGIONAL),
u
press and hold down the TRAF•RDS
button = for longer than two sec-
onds.
The RDS function is active if RDS appears
on the display.
52
RDS functions
To deactivate,
u
press and hold down the TRAF•RDS
button = for longer than two sec-
onds.
The RDS symbol disappears from the dis-
play.
Switching REGIONAL on/off
u Press the MENU button >.
AF The display shows "MENU".
u
Press the
until "REG ON" or "REG OFF" appears
on the display.
u Press the button 2 to open the sub-
menu.
To switch REGIONAL on/off,
u press the button 2.
u Press the MENU button >.
To exit the menu,
press the ESC button <.
u
Selecting the waveband/memory
bank
This device can receive programmes broad-
cast over the FM frequency range as well as
the MW and LW (AM) wavebands. There are
three memory banks available for the FM
waveband (FM1, FM2 and FMT) and one
for each of the MW and LW wavebands.
Five stations can be stored in each memory
bank.
To switch between the FM memory banks
(FM1, FM2 and FMT) and the MW and LW
wavebands,
u briefl y press the BND•TS button 5.
button 2 repeatedly
or