Related Manuals for Blaupunkt CALGARY MP36
Summary of Contents for Blaupunkt CALGARY MP36
- Page 1 Radio CD MP3 Calgary MP36 7 646 175 310 Operating instructions http://www.blaupunkt.com...
- Page 3 Button to switch the device on/ off and operate the volume mute function. button for detaching the con- trol panel (release panel). button to eject a CD from the device. Volume control CD compartment AUDIO button to adjust the bass, treble, balance and fader. To select an equalizer preset.
-
Page 4: Table Of Contents
Notes and accessories ... 32 Removable control panel ... 33 Switching on/off ... 34 Adjusting the volume ... 35 Radio mode ... 37 Adjusting the tuner settings ... 37 Switching to radio mode ... 37 RDS functions ... 37 Selecting the waveband / memory bank ... - Page 5 You cannot switch the device on/off us- ing the remote control. You can find out from your Blaupunkt dealer or on the Internet at www. blaupunkt.com which remote controls can be used with your car sound sys-...
-
Page 6: Removable Control Panel
You can use all Blaupunkt and Veloci- ty amplifiers. You can connect the following Blau- punkt CD changers: CDC A 08, IDC A 09 and CDC A 03. As a way of protecting your car radio against theft, the unit is equipped with a removable control panel (release pa- nel). - Page 7 ➮ First, pull the control panel straight off the unit and then out towards the left. The device switches off. All the current settings are saved. Any CD already inserted in the unit re- mains there. ➮ Slide the control panel from left to right into the unit’s guide.
- Page 8 Note: If the vehicle ignition was switched off before you inserted the CD, you will first have to switch on the device by pressing button 1 in order to start playing the CD. ➮ Remove the control panel. The unit switches off. ➮...
- Page 9 Note: To protect your hearing, the pow- er-on volume is limited to a value of “38”. If the volume level was higher than this when the device was last switched off and the “LAST VOL” setting is activated, the system will reset the volume to “38”...
- Page 10 To ensure that the tuner works proper- ly, the device must be configured for the region in which it is being used. You can choose between Europe (EU- ROPE), United States (USA), South America (S-AMERICA) and Thailand (THAI). By default, the tuner is set to the region in which the device was sold.
- Page 11 If you want to use the RDS functions (AF and REGIONAL), ➮ press and hold down the TRAF RDS button : for longer than two seconds. The RDS function is active when the RDS symbol is shown in the display. ➮...
- Page 12 You can choose whether the radio should only tune into stations provid- ing good reception or whether it can also tune into those with a weak re- ception. ➮ Press the MENU button 7. ➮ button 8 re- Press the peatedly until “SENS”...
- Page 13 Scanning begins. “SCAN” appears briefly in the display followed by a flash- ing display of the current station name or frequency. ➮ Press the MENU button 7. Scanning stops and the radio contin- ues playing the station that it tuned into last.
-
Page 14: Radio Mode
➮ button 8 to Press the switch PTY ON or OFF. ➮ Press the MENU button 7. You can select the language in which the programme types are displayed. The following are available: “DEUTSCH”, “ENGLISH” and “FRANÇAIS”. ➮ Press the MENU button 7. ➮... - Page 15 Your device is equipped with an RDS- EON receiver. EON stands for En- hanced Other Network. Whenever a traffic announcement (TA) is broadcast, the system switches au- tomatically from a station that does not provide traffic reports to the appropri- ate traffic information station within the broadcasting network that does.
- Page 16 To ensure the system functions prop- erly, only use CDs labelled with the compact disc logo. Problems might be experienced when playing copy-pro- tected CDs. Blaupunkt cannot guaran- tee the proper functioning of copy-pro- tected CDs! Besides being able to play audio CDs on this device, you can also play CDs containing MP3 music files.
- Page 17 ➮ Press the 5 MIX button ;. “MIX CD” appears briefly in the display and the MIX symbol lights up. The next randomly selected track will then be played. ➮ Press the 5 MIX button ; again. “MIX OFF” appears briefly in the dis- play and the MIX symbol disappears.
- Page 18 Some CDs include CD text. The CD text might contain the names of the artist, album and track. You can allow the CD text to be dis- played as scrolling text every time you switch to another track. The default dis- play will appear again after the whole CD text has been shown once.
- Page 19 You can also use this car sound sys- tem to play CD-Rs and CD-RWs that contain MP3 music files. The various combinations of CD burn- ers, CD burning software and CD blanks may lead to problems arising with the device’s ability to play certain CDs.
- Page 20 “002”, etc.) at the beginning of each file name - you must include the lead- ing zeros. MP3 tracks can contain additional in- formation such as the artist, album and track names (ID3 tags). This device can display ID3 tags (version 1). When creating (encoding) MP3 files from audio files, you should use bit rates up to a maximum of 256 kbits/...
- Page 21 One of the following scrolling texts is displayed once every time the track is changed. Afterwards, the configured default display is shown. The available scrolling texts are: Directory name (“DIR NAME”) Track name (“SONG NAME”) Album name (“ALBM NAME”) Artist name (“ARTIST”) File name (“FILE NAME”) Note: The artist, track and album names...
-
Page 22: Setting The Scanning Time
To cancel MIX, ➮ briefly press the 5 MIX button ;. “MIX OFF” appears in the display and the MIX symbol disappears. You can scan (briefly play) all the tracks on the CD. ➮ Press and hold down the MENU button 7 for longer than two sec- onds. -
Page 23: Fast Searching
Note: Information on handling CDs, in- serting CDs and operating the CD changer can be found in the oper- ating instructions supplied with your CD changer. ➮ button = re- Press the SRC peatedly until “CHANGER” ap- pears in the display. The device starts playing the first CD that the CD changer detects. - Page 24 To stop the current track or current CD from being repeated, ➮ briefly press the 4 RPT button ;. “RPT OFF” appears and RPT disap- pears from the display. To play the tracks on the current CD in random order, ➮...
- Page 25 To display the clock time briefly, ➮ press and hold down the SRC button = until the clock time ap- pears in the display. To set the clock time, ➮ press the MENU button 7. ➮ button 8 re- Press the peatedly until “CLOCK SET”...
-
Page 26: Sound
You can adjust the sound settings (bass and treble) separately for each source (radio, CD/MP3, CD changer or AUX). The volume distribution settings (bal- ance and fader) apply to all the audio sources (except for traffic announce- ments). You can only adjust the balance and fader settings for traffic announce- ments whilst a traffic announcement is actually being played. -
Page 27: X-Bass
This device is equipped with an equal- izer that has been preset with settings for the “ROCK”, “POP” and “CLASSIC” music styles. To select an equalizer preset, ➮ press the AUDIO button 6. “BASS” appears in the display. ➮ button 8 repeatedly Press the until “POP”, “ROCK”, “CLASSIC”... - Page 28 If you want to connect an external au- dio source, you will need an adapter cable. You can obtain this cable (Blau- punkt no.: 7 607 897 093) from your authorised Blaupunkt dealer. Note: If no CD changer is connected, the AUX input must be activated in the menu.
- Page 29 Output power: 4 x 25 watts sine in accordance with DIN 45 324 at 14.4 V 4 x 45 watts max. power Wavebands in Europe: FM : 87.5 - 108 MHz MW : 531 - 1 602 kHz LW : 153 - 279 kHz FM frequency response: 35 - 16,000 Hz...
- Page 30 Bitte den ausgefüllten Gerätepass sicher aufbewahren! Please keep the filled-in radio pass in a safe place! Prière de conserver soigneusement la carte d’autoradio remplie ! Tenete per favore il libretto di apparecchio, debitamente riempito, in un posto sicuro! Bewaar de ingevulde apparaatpas op een veilige plaats! Vänligen förvara ifyllt apparatpass på...
- Page 31 Gerätepass Gerätepass Gerätepass Gerätepass Gerätepass Name: Typ: Serien-Nr.: BP ... Blaupunkt GmbH, Robert-Bosch-Straße 200, D-31139 Hildesheim 02/06 - CM-AS/SCS (dt, gb, fr, it, nl, sw, es, pt, dk) Fax: 05121-49 4002 01-610 39 391 02-525 5263 44-898 644 09-435 99236...