Blaupunkt BRISBANE SD48 7 648 000 310 Operating And Installation Instructions page 35

Display
u
Press the or
between the colour components.
u
Press the or
the value of a colour component.
When you have fi nished making your chang-
es,
u press the MENU button >.
To exit the menu,
u press the ESC button <.
Selecting the colour of the display
illumination from the colour scan
(COL SCAN)
u Press the MENU button >.
The display shows "MENU".
u
Press the or
edly until "COL SCAN" appears on the
display.
u button 2 to start the col-
Press the
our seek.
The device starts changing the display illu-
mination colour. During the colour scan, the
display intermittently shows "SCANNING"
and "OK (MENU)".
Note:
You can cancel the colour scan by
pressing the or
adjusting a new display colour.
To select the currently set colour,
u press the MENU button >.
To exit the menu,
u press the ESC button <.
72
button 2 to switch
button 2 to adjust
button 2 repeat-
button 2 without
Switching the constant colour change
for the display illumination on/off
(SCAN)
You can select a constant colour change as
the colour of the display illumination. If the
colour change is activated, the display col-
our changes constantly. The colour change
is switched on or off in the menu.
Press the MENU button >.
u
The display shows "MENU".
u
Press the or
until "SCAN ON" or "SCAN OFF" ap-
pears on the display.
u button 2 to call up the
Press the
submenu.
u button 2 to toggle be-
Press the
tween ON (colour change on) or OFF
(colour change off).
When you have fi nished making your chang-
es,
press the MENU button >.
u
To exit the menu,
u press the ESC button <.
button 2 repeatedly