Table of Contents
Advertisement
About Certifications
manuals and documents for installation provided with the system
that are integral to the tested system are outside the scope of this
standard. The installation instructions indicate that the energy
storage systems are to be installed in accordance with the national
and local electrical codes and other applicable codes. This standard
assumes that the final installation of the energy storage system
will be performed by qualified service personnel in accordance with
the applicable installation instructions, installation practices and
national installation codes. Energy storage systems are intended for
installation subject to approval by the Authority Having Jurisdiction.
•
CSA 22.2.107.1: This Standard applies to AC and DC type power
conversion equipment (PCE) that
a) is of dry or liquid-filled construction
b) has a rated voltage not exceeding 1500 V
c) is for commercial, industrial, and residential indoor and
outdoor use in nonhazardous locations in accordance with the
Rules of the Canadian Electrical Code, Part I.
•
IEE 1547: Standard for Interconnecting Distributed Resources with
Electric Power Systems was approved by the IEEE Standards Board
in June 2003. It was approved as an American National Standard in
October 2003. The published standard is available from the IEEE Std
1547-2003.
•
NEMA 1: Intended for indoor use primarily to provide a degree of
protection against contact with the enclosed equipment or locations
where unusual service conditions do not exist.
12
Installation Manual
Hide quick links:
Advertisement
Table of Contents
