Procedures for installation of the switch
Figure 14: Rack mount
Installing a rear mounted switch in an equipment rack
The Ethernet Routing Switch 5530-24TFD and 5600 Series switches offer the option of
installing the switch in a rear mounted configuration. This option allows the switch to be
installed with the back panel facing forward. This procedure describes how to install a rear-
mounted switch.
Prerequisites
#2 Phillips screwdriver
1. Attach a bracket to each side of the switch using a #2 Phillips screwdriver as shown
68
Avaya Ethernet Routing Switch 5000 Series Installation
in
Figure 15: Attaching rear mounted switch brackets
with the round holes goes on the right side of the switch where the round fan vents
are located.
on page 69. The bracket
December 2010