Screen Configuration; Screen Configuration; Main Screen - Delta Electronics HMC Series Manual

2.1 Screen configuration

2.1.1 Main Screen

When the system is started up, the main screen will pop up which is showed as below:
(1) Status bar: It shows the title of the current screen, program number, program name,
current user, date and time.
(2) Operation in main screen: Users can do homing, status display and settings of
injection molding machine.
Note: Disable the function of [Work with injection molding machine] and the system will turn
on the signal of [Not to use take-out arm].
(3) Servo position: Display the servo's current position of each axis. Users can press
this button to switch between the main system and subsystem.
(4) Function key: Click the button to enter the corresponding page.
(5) System status: It includes the arm's current posture, the arm's posture when it is in
molding area and its limit setting at transverse direction. When the system is not
applied to the power, the output condition of operating [Main arm returns to the
original position] will be: [When it is standby in molding area, the take-out arm
retrieves (signal On)] or [When it is standby in non-molding area, the take-out arm is
not in molding area (signal Off)].
28
HMC Take-out Robot for Injection Molding Machine
June, 2015