Toyota AVENSIS Manual page 110

110
2. Instrument cluster
■
When disconnecting and reconnecting battery terminals
The following information data will be reset:
●
Elapsed time
● Average fuel consumption
●
Driving range
●
Average vehicle speed
■
Liquid crystal display
Small spots or light spots may appear on the display. This phenomenon is
characteristic of liquid crystal displays, and there is no problem to continue
using the display.
■
Setting display automatic suspension
In the following situations, the setting display will be suspended.
●
When a message appears
●
When the vehicle begins to move
■
Setting the clock
The clock can be adjusted by the settings menu.
Press the "DISP" switch to adjust the
1
hours.
After setting the hours, wait for 5 sec-
onds until the bar disappears, and con-
firm that the hour has been input.
Press the "DISP" switch to adjust the
2
minutes.
After setting the minutes, wait for 5 seconds until the bar disappears, and
confirm that the minutes has been input.
WARNING
■
The information display at low temperatures
Allow the interior of the vehicle to warm up before using the display. At
extremely low temperatures, the display monitor may respond slowly, and
display changes may be delayed.
For example, there is a lag between the driver's shifting and the new gear
number appearing on the display. This lag could cause the driver to down-
shift again, causing rapid and excessive engine braking and possibly an
accident resulting in death or injury.
■
Cautions during setting up the display
As the engine needs to be running during setting up the display, ensure that
the vehicle is parked in a place with adequate ventilation. In a closed area
such as a garage, exhaust gases including harmful carbon monoxide (CO)
may collect and enter the vehicle. This may lead to death or a serious
health hazard.