7
Ethernet Recommendations:
The PLC should be set up for Point To Point (Unicast) connection instead of Multicast
connection. If Multicast is used, a managed switch is recommended / required.
The LINKnet module should be in a LAN / VLAN with only other equipment associated
with its operation. Broadcast traffic on the LAN / VLAN should be kept to a minimum.
Web Page:
Communication differences:
The AC30 Series LINKnet drive does not support a webpage.
When using Ethernet communication to access drive parameters, the protocol for
accessing these parameters is different when using the LINKnet platform. When using
the Codesys platform, parameters could be accessed directly via Modbus registers. In
the LINKnet platform, parameters must be configured using the software tool DSE.
AC30 Series LINKnet Product Manual HA474739U001