Getting Started - Gkp Setup Wizard; Purpose Of The Setup Wizard; Starting The Setup Wizard; Running The Setup Wizard - Parker AC70 Product Manual

English

Getting Started - GKP Setup Wizard

The GKP can be fitted remotely – see Chapter 4 "Installation" of the AC30 series Product Manual for details.

Purpose of the Setup Wizard

The purpose of the setup wizard is to configure the drive in a clear and concise manner.
First familiarize yourself with Chapter 7 "Graphical Keypad" of the AC30
series Product Manual, for the keypad functions.

Starting the Setup Wizard

The Setup Wizard is automatically invoked when the drive is reset to factory
default settings. The setup wizard may be invoked at any other time by
navigating to the Welcome Screen at the "top" of the menu tree the pressing
the key, Soft Key 1.

Running the Setup Wizard

At each point in the wizard pressing the OK key selects the displayed
value and moves on to the next step. Pressing Soft key 1 moves back
a step. Pressing the UP and DOWN keys modifies the selected value.

Setup Wizard Stages

After selecting the required view level and language, the next option presented is "Set Factory Defaults".
Changing this parameter to TRUE then pressing OK resets all parameters back to the default value determined
by the AC30 series hardware configuration. If this choice is left FALSE the setup wizard starts with all
parameters with their previously set values. Accepting each choice without change by pressing OK will result in
no change to the drive's configuration.
The rest of the Setup Wizard consists of a several sections. Each section corresponds to a functional component
of the drive, for example:
 Application selection
 IO Option, (including the Encoder)
 Analog input and output ranges
 Motor Data
If not required, any section may be skipped.
The default setting for all parameters depends on earlier answers and on the physical configuration of the drive.
All data entered is automatically saved without the need for any additional commands.

Finalising Setup

Once the Setup Wizard has been run to completion the feature is automatically disabled. Re-starting the drive
will not cause the Setup Wizard to be run again. (If it is desired to re-run the Setup Wizard, this can be achieved
as detailed above in "Starting the Setup Wizard").
For complete details go to "Chapter 9 Setup Wizard".

Ethernet Communications

Connecting and disconnecting the Ethernet cable.
See Chapter 12 Ethernet of the AC30 series Product Manual for this information.
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com
 Motor Control
 Fieldbus options
 On-board Ethernet
 Auto tune
1-10
Soft Key 1
OK key