English
Getting Started - GKP Setup Wizard
The GKP can be fitted remotely – see Chapter 4 Installation of the AC30 Product Manual for details.
Purpose of the Setup Wizard
The purpose of the setup wizard is to configure the drive in as clear and concise
manner.
Starting the Setup Wizard
The Setup Wizard is automatically invoked when the drive is reset to factory default
settings. The setup wizard may be invoked at any other time by changing the
parameter "Run Setup?" to YES (you will find this under "Commissioning::Quick
Setup::") then returning to the top of the menu tree, (by pressing the left key
repeatedly.
Running the Setup Wizard
On entry to the Setup Wizard, the first action is to set the language that is to be used. The language may be
selected by using the UP and DOWN keys. Pressing the OK key confirms the selection and moves on to the
next step.
The rest of the Setup Wizard consists of a several sections. Each section corresponds to a functional component
of the drive, for example:
If not required, any section may be skipped.
The default setting for all parameters depends on earlier answers and on the physical configuration of the drive.
All data entered is automatically saved without the need for any additional commands.
Finalising Setup
Once the Setup Wizard has been run to completion the feature is automatically disabled. Re-starting the drive
will not cause the Setup Wizard to be run again. (If it is desired to re-run the Setup Wizard, this can be achieved
as detailed above in "Starting the Setup ").
Ethernet Communications
Connecting and disconnecting the Ethernet cable.
See Chapter 12 Ethernet of the AC30 Product Manual for this information.
Application selection
Motor Data
Analog input and output ranges
Fieldbus options
On-board Ethernet
Autotune
1-13