Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Disengage the PTO, engage the parking brake.
3.
Shut off the engine and remove the key.
4.
For easier access, raise the front of the machine
and support it using jack stands rated for your
machines.
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
2
Preparing the Mower Deck
No Parts Required
Procedure
1.
Remove the existing mower blades; refer to the
Operator's Manual for the machine.
2.
Remove the 2 bolts and 2 nuts securing the
cutoff baffle to the deck and remove the cutoff
baffle
(Figure
1).
Note:
Retain the baffle for converting back to
side discharge.
54-inch deck shown
1. Nut
2. Cutoff baffle
3.
Install the fasteners in the same holes that they
were originally removed from
3
Installing the Right Baffle
Parts needed for this procedure:
1
Right baffle
1
Carriage bolt (5/16 x 3/4 inch)—48-inch decks only
2
Carriage bolt (5/16 x 3/4 inch)—54-inch decks only
3
Nut (5/16 inch)—48-inch and 60-inch decks only
4
Nut (5/16 inch)—54-inch decks only
2
Figure 1
3. Bolt
(Figure
1).
g209902
Advertisement
