Table of Contents
Advertisement
INSTALLATION
Continued
INSTALLING LOG SET AND SCREEN
1. Remove log packaging material and discard
packaging. Gently place log on burner support
(see Figure 32). Log should fi t fl at against top of
burner support and log locator tabs fi t into slots
under log. Do not allow log to contact fl ame. If
fl ame contacts log, soot will be created.
2. Reattach screen by placing notches in screen
frame over shoulder screws and pushing down.
Log
Screen
Figure 32 - Installing Log and Screen
OPERATION
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow
these instructions exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the ap-
pliance area for gas. Be sure to smell next to
the fl oor because some gas is heavier than
air and will settle on the fl oor.
126872-01C
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
• Immediately call your gas supplier from a
• If you cannot reach your gas supplier, call
C. Use only your hand to push in or turn the gas
Shoulder
control knob. Never use tools. If the knob will
Screw
not push in or turn by hand, don't try to repair
it, call a qualifi ed service technician or gas
supplier. Force or attempted repair may result
in a fi re or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualifi ed
service technician to inspect the appliance
and to replace any part of the control system
and any gas control which has been under
water.
Burner Support
with Log Locator
Tabs
fi replace with the fi replace screen in place.
Make sure fi replace screen is installed
before running fi replace.
NOTICE: During initial operation of new
fi replace, burning logs will give off a
paper-burning smell. Open window to
vent smell. This will only last a few hours.
1. STOP! Read the safety information in column
1.
2. Make sure equipment shutoff valve is fully
open.
3. Set switch in the OFF position.
automatically within one minute when
the selector switch is in the ON position
after the pilot is lit.
SuperiorFireplaces.us.com
OPERATION
Continued
any phone in your building.
neighbor's phone. Follow the gas supplier's
instructions.
the fi re department.
LIGHTING
INSTRUCTIONS
WARNING: You must operate this
WARNING: Burner will come on
23
Advertisement
Table of Contents
