Table of Contents
Advertisement
WARNING: Do not connect the
thermostat to a power source. Elec-
trical shock and/or a fi re hazard will
occur.
6. Connect one bare wire end to each terminal ("W"
and "R") of the thermostat base (see Figure 31).
7. Install base onto wall with provided screws.
Feed wires through rectangular slots
Figure 30 - Back View of Thermostat Base
Terminal "W"
Terminal "R"
Figure 31 - Thermostat Base Terminals "W"
and "R"
8. Move temperature adjustment back and forth
to ensure bimetal is free from restrictions.
9. Replace cover onto base. (Upon installation,
thermostat must be allowed to stabilize at room
temperature for a minimum of 30 minutes for
proper operation).
10. Set switch on fi replace to Auto position.
11. Set temperature adjustment to desired set-
ting. This thermostat has been electronically
calibrated at the factory. No adjustment or
leveling is necessary.
22
INSTALLATION
Continued
OPTIONAL WALL SWITCH - GWMS2
installation instructions. Installa-
tion should be done by a qualifi ed
installer familiar with low-voltage
wiring procedures.
switch to any electrical source!
Electrical shock and/or fi re hazard
will occur.
1. Connect one terminal of 25 ft. wire to bottom
contact of switch (see Figure 29, Page 21).
2. Connect remaining wire terminal to "TH"
terminal on control valve. Make sure that wire
terminals are in the positions on your unit as
pictured in Figure 29, Page 21. If wires are not
"crossed" thermostat will not work.
3. Route 25 ft. wire to a convenient location to
mount your wall switch (no outside walls).
switch to a power source. Electrical
shock and/or fi re hazard will occur.
W
IMPORTANT: Wire may be shortened but must not
be lengthened.
4. Connect one bare wire end to each of the
terminals of provided wall switch.
5. Install wall switch and cover in wall.
R
SuperiorFireplaces.us.com
WARNING: Read and follow
WARNING: Do not connect this
WARNING: Do not connect the
126872-01C
Advertisement
Table of Contents
