52 Installing the 8010co chassis
Step
1
2
3
4
5
Installing and Maintaining the Ethernet Routing Switch 8000 Series Chassis
Copyright © 2007, Nortel Networks
.
Action
Place the installation shelf at the bottom of the rack.
Holding the installation shelf in position, align the shelf's mounting
rail with the two holes on either side of the vertical rack support.
Insert a hex-head screw through the mounting hole of each
installation shelf and into the corresponding hole in the rack.
See the figure
"Installing the installation shelf in a Hendry rack"
(page
52).
Installing the installation shelf in a Hendry rack
Tighten each screw with a nutdriver.
Using a Phillips screwdriver, remove the five screws securing each
of the two mounting rails to the 8010co chassis.
See the figure
"Removing the mounting rails from the 8010co
chassis" (page
53).
Nortel Ethernet Routing Switch 8600
NN46205-303 01.01 Standard
4.1 2 January 2007
Nortel Networks Confidential