Partial Knitting - Singer SRP-50 Instruction Book

Par~
decreasing stitches
PARTIAL KNITTING is a practical method for shaping a
gentle slope such as a shoulder, back of slacks and so on.
Note:
In case of knitting pushing up end needle to 0 position
like K3. P3. rib, variation swing, pile knitting and drive
lace knitting, etc., push up needle to C position since
needles in 0 position can not knit in partial knitting.
Partial knitting without involving
"swing"
This method applies to double rib, K1.P1. rib, K2.P2. rib,
K3. P3. rib (wide ribbing), punch tuck rib, pin tuck, English
and double English rib, etc.
Partial knitting by decreasing stitches.
Set Russel Levers on Knitter and Ribber Carriage to I and
-positions respectively.
(1)
On the side opposite Carriage, push up needles to be
decreased to 0 position.
(2) Knit one row, then yarn will be laid over needles in
0 position.
(3) To prevent a hole from being formed in the fabric,
bring yarn under the first inside needle in 0 position .
(If partial knitting is required on both sides, apply
step ( 1) 'before knitting the next row.)
Be sure that yarn is not caught in Sinker Post "A".
(4) Knit one row.
This completes the first operation of partial knitting.
(5) Repeat steps (1)-(4).
- 4 8 -