Table of Contents
Advertisement
0-
4 Place P Carriage with P Presser attached on the
right side of Knitter Needle Bed (refer to page 11 ).
Move P Carriage to the left and back again so that
stitches on knitter are removed and the needles
are aligned in B position again.
- 4 1 -
- 5 Set Cam Lever to SliP (
e,
S) and knit 3 rows
with waste yarn.
- 6 Place P Carriage on the left side of Ribber Needle
Bed (refer to page 11), and slide it to the right to
push up needles to C position.
- 7 Exchange waste yarn for pile yarn in main Yarn
Feeder.
Set Auxiliary Yarn Feeder Lever to P (right) posi-
tion, and thread ground yarn into Auxiliary Yarn
Feeder following the manner below.
(1
).
Lower Ribber Needle Bed to the middle position by
depressing Drop Lever (red mark) once.
(2) Thread ground yarn through Auto-Tension.
(3) Make a loop on yarn end and hold it above Auxiliary
Yarn Feeder.
(4) Insert Hook Tool from underneath through Auxiliary
Yarn Feeder "A" and Yarn Guide "B", then catch
yarn loop.
(5) Pull Hook Tool downwards threading yarn through
Yarn Guide and Auxiliary Yarn Feeder.
Hide quick links:
Advertisement
Table of Contents
