Cast On For Tighter Edge - Singer SRP-50 Instruction Book

CAST ON FOR TIGHTER EDGE
~ ~
\
,, CD \
,
\
\
I
4IHHIHIIIHHHHHH
I
i
I I I
\
:
\ I
\ I
' ®
• I
!:=...
0.
ll_
~
r
(I)~
a
r
(:a
~
~1 ~IJ{Q
.,..
---=
~=2J
I~
To make the east-on edge of the fabric tighter, when knit-
ting with thinner yarn, set the Carriages as instructed in the
operation table, but operate them following the procedure
set forth below:-
0-
1 Set machine controls for the initial row and have
Carriage on the right side.
0-
2 Arrange needles, and knit the initial row from the
right to the left.
0 -
3 Suspend Cast-on Comb with Weights.
Insert Cast-on Comb so that its teeth '~"confront
with Knitter Sinker Posts "8" as illustrated.
• Disconnect Ribber Carriage and move it twice ace ross
the needles to drop stitches on Ribber needles.
If
Cast-on Comb is suspended incorrectly, it will drop
onto the floor.
• Connect Ribber Carriage and knit one row with same
Carriage settings.
0-4'"'-'0-6
As required in operation table, knit subsequent 3 rows.
CAST-ON FOR TIGHTER EDGE IS COMPLETED.
When the garment has been completed, pull the yarn of the
initial row of east-on towards the direction opposite to its
yarn end slightly before steaming it with a steam iron so
that the stitches on the initial row align neatly.
After steaming the edge has been finished, pull out the yarn
completely in the same direction as above.
-23 -