Siemens SINAMICS G120C Getting Started page 32

Commissioning
4.2 Further settings
P-No. Note
r0755 CO: CU analog inputs actual value in percent, AI0
(terminals 3/4) [100 ≙ 100%]
p0756 CU analog input type (terminals 3, 4)
0 Unipolar voltage input (0 V ... +10 V)
1 Unipolar voltage input monitored
(+2 V... +10 V)
2 Unipolar current input (0 mA ... +20 mA)
3 Unipolar current input monitored (+4 mA ...
+20 mA)
4 Bipolar voltage input (-10 V...+10 V)
8 No sensor connected
p0757 CU analog input characteristic value x1
p0758 CU analog input characteristic value y1 [%]
p0759 CU analog input characteristic value x2
p0760 CU analog input characteristic value y2 [%]
p0761 CU analog input wire break monitoring response
threshold
p0771 CI: CU analog output signal source, AO 0
(terminals 12, 13) [100 ≙ 100%]
r0772 CU analog output, output value currently referred
r0774 CU analog output, output voltage/current actual
[100% ≙ p2001]
p0775 CU analog output activate absolute value
generation
p0776 CU analog output type
0 Current output (0 mA ... +20 mA)
1 Voltage output (0 V... +10 V)
2 Current output (+4 mA ... +20 mA)
30
P-No. Note
p0777 CU analog output characteristic value x1 [%]
p0778 CU analog output characteristic value y1 [V]
p0779 CU analog output characteristic value x2 [%]
p0780 CU analog output characteristic value y2 [V]
p0782 BI: CU analog output invert signal source, AO 0
(terminals 12,13)
r0785 BO: CU analog outputs status word
.00 1 = AO 0 negative
p0795 CU digital inputs, simulation mode
p0796 CU digital inputs, simulation mode setpoint
p0797 CU analog inputs, simulation mode
p0798 CU analog inputs, simulation mode setpoint
p0802 Data transfer with memory card as source/target
p0803 Data transfer with device memory as
source/target
p0804 Data transfer start
12 Start transfer of the GSD for PROFIBUS
master on the memory card
p0806 BI: Inhibit master control
r0807 BO: Master control active
p0809 Copy Command Data Set CDS
p0810 BI: Command data set selection CDS bit 0
p0819 Copy drive data set DDS
p0820 BI: Drive data set selection DDS, bit 0
p0826 Motor changeover, motor number
r0835 CO/BO: Data set changeover status word
r0836 CO/BO: Command data set CDS selected
r0837 CO/BO: Drive data set DDS selected
p0840 BI: ON/OFF (OFF1)
p0844 BI: No coast down/coast down (OFF2) signal
source 1
p0845 BI: No coast down/coast down (OFF2) signal
source 2
p0848 BI: No quick stop/quick stop (OFF3) signal source
1
p0849 BI: No quick stop/quick stop (OFF3) signal source
1
p0852 BI: Enable operation
p0854 BI: Master control by PLC
p0855 BI: Unconditionally release holding brake
Getting Started, 03/2012, FW V4.5, A5E03831830B AA
SINAMICS G120C frequency converter