Sc 4Xx (Image Transfer And Transfer Errors); Sc 5Xx (Motor And Fusing Errors) - Ricoh SP 330DN Field Service Manual

No. Type
SC268 D Laser unit thermistor error





1.
2.

SC 4xx (Image Transfer and Transfer Errors)

No. Type
SC491 D Bias leak
An error signal is detected for 0.2 seconds when changing the development unit.



1.
2.
3.
4.
5.

SC 5xx (Motor and Fusing Errors)

No. Type
SC520 D Main motor error




Error Name/Error Condition/Major Cause/Solution
The laser unit thermistor detected a temperature lower than -30°C for more than
4 sec.
The laser unit thermistor detected a temperature higher than 105°C for more
than 1 sec.
Thermistor disconnected (causes an extremely low temperature reading)
Defective harness
Defective main board
Turn the power OFF and ON.
Replace the laser unit thermistor.
Error Name/Error Condition/Major Cause/Solution
HVP harness damaged and short circuited
Defective the HVP
AIO terminal damaged and short circuited
Turn the power OFF and ON.
Replace the main board.
Replace the transfer roller.
Replace the interface harness of the HVP.
Replace the HVP.
Error Name/Error Condition/Major Cause/Solution
The machine does not detect a main motor lock signal within 2 seconds after
the main motor started to rotate.
The machine does not release a main motor lock signal within 2 seconds after
the main motor switched off.
The machine detects a main motor lock signal every 100 msec. for seven times
consecutively, after the main motor started to rotate stably.
Torque overload
6.Troubleshooting
173