Advertisement
35. Rotate the idler pulley until the shift lever spring
can be hooked into the hole in the pulley bracket
and onto the stud as shown in
G016230
1. Shift lever spring
36. Route the belt onto the driver pulley, idler pulley,
and driven pulley as shown in
G016231
1. Drive belt
Important:
Ensure that the belt is centered
on the pulleys and in the grooves
Figure
15.
Figure 15
Figure
16.
Figure 16
(Figure
Figure 17
37. Mount the belt cover to the groomer housing
assembly with 3 locknuts
G016233
g016230
1. Belt cover
38. Center the roller between the adjuster arms and
tighten the mounting bolts
39. Lubricate the groomer bearings
Figure
20) weekly or after every 10 operating
hours, before extended periods of non-use, and
immediately after every washing. Pump grease
into the fittings until grease is purged onto the
groomer shaft. Wipe excess grease from the
seals and shaft.
Note:
Operate the groomer for 30 seconds
after greasing. Disengage the cutting unit and
wipe excess grease from the seals and shaft.
g016231
17).
g216642
6
(Figure
18).
Figure 18
(Figure
14).
(Figure 19
G027982
Figure 19
g016233
and
g027982
Advertisement
