Advertisement
Installing the Groomer
Drive System
Important:
Read these instructions thoroughly
before setting up or operating the groomer.
Failing to follow setup or operating instructions in
this manual may result in damage to the cutting
unit and/or the groomer or the turf.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1. Separate the cutting unit from the traction unit.
Refer to the Operator's Manual for procedure.
2. Loosen the screws securing each end of the
front roller to the height-of-cut arms
G016224
1. Roller mounting screws
2. Height-of-cut arm
3. Remove the plow bolts, washers, and locknuts
securing the height-of-cut arms to each end of
cutting unit
(Figure
arms and roller assembly.
Note:
Retain all parts for use if the groomer is
ever removed.
4. Remove the height-of-cut adjusting screws from
the height-of-cut arms
5. Remove the 2 bolts and nuts securing the
counterweight to the right end of the cutting unit.
Remove the counterweight
(Figure
Figure 1
3. Carriage bolt, washer, and
locknut
4. Adjusting screw
1). Remove the height-of-cut
(Figure
1).
(Figure
2).
1).
1. Counterweight
6. Remove the bearing nut from the reel shaft
(Figure
2).
7. Loosen the captive bolt securing the belt cover
to the left end of the cutting unit until you can
remove the cover
g016224
1. Belt cover bolt, captive
2. Belt cover
8. Loosen the belt tensioning nut and remove the
belt
(Figure
9. Loosen the 2 set screws securing the lower
pulley and remove the pulley from the reel shaft
(Figure
4).
2
2
1
Figure 2
2. Bearing nut
(Figure
3).
2
1
Figure 3
3. Belt
4. Belt tensioning nut
3).
G016289
g016289
4
3
g017662
g017662
Advertisement
