Advertisement
15. Apply grease to the seals in the drive assembly
bearing support and to the end of the groomer
shaft
(Figure
8).
G027981
1. Groomer shaft
16. Slide the splined end of the groomer shaft into
the drive-assembly bearing support
17. Apply grease to the seal surface of the driven
pulley, as shown in
Note:
Do not put grease on the area where the
belt will ride.
18. Slide the pulley onto the groomer shaft
9).
G016228
1. Groomer shaft
2. Driven pulley
19. Secure the pulley to the shaft with a flange
locknut and torque to 23 to 28 N·m (17 to 21
ft-lb)
(Figure
9).
20. Apply grease to the seal in the left support plate
and to the end of the groomer shaft
Figure 8
2. Seal lip
(Figure
Figure
9.
Figure 9
3. Flange lock nut
4. Apply grease here
(Figure
21. Insert other end of the groomer shaft into the left
support plate
22. Install the reel belt-drive assembly using the
previously removed bolts and ensure that the
side plate rotates freely
23. Install the lower pulley onto the reel drive shaft,
securing it with the 2 set screws onto the key
on the shaft
24. Install the drive belt and tension it as described
in the traction unit Operator's Manual.
25. Secure the groomer drive pulley to the reel shaft
on the right side of the reel and torque it to 170
N·m (125 ft-lb)
g027981
Note:
to ensure proper installation. Failure to properly
torque the drive pulley can result in the assembly
unscrewing itself during operation.
8).
(Figure
1
1. Drive pulley
g016228
9).
4
(Figure
5).
(Figure
(Figure
4).
(Figure
10).
The use of an impact gun is not enough
Figure 10
5).
G016218
g016218
Advertisement
