Toro 04259 Installation Instructions Manual page 5

26. Insert a bushing into the hole in the groomer
drive assembly (Figure
G016215
1. Bushing
27. Thread the height-of-cut adjusting screw into the
top of the right adjuster arm assembly
12).
2
G016216
1. Height-of-cut screw
28. Install the right adjuster arm assembly to the
cutting unit side plate using the existing plow
bolt, nut, and a new washer.
Note:
Make sure that the rod end of the
height-of-cut arm assembly slides into the
bushing in the hole in the groomer drive
assembly (Figure
29. Secure the adjuster arm assembly rod end to
the groomer drive assembly with a Belleville
washer and locknut
Note:
Do not overtighten the locknut. The
washer should be compressed but the arm must
be free to pivot.
11).
2
1
Figure 11
2. Hole in groomer drive
1
Figure 12
2. Right adjuster arm
assembly
12).
(Figure 13).
1. Rod end of the
g016215
height-of-cut assembly
2. Locknut
30. Insert the roller shaft into the right adjuster arm
and loosely secure it with the bolt
(Figure
1. Roller shaft bolt
31. Thread the height-of-cut adjusting screw into the
g016216
top of the left adjuster arm assembly
32. Insert the roller shaft into the left adjuster arm.
Do not tighten the bolt at this time.
33. Install the left adjuster arm assembly to the
cutting unit side plate using the existing plow
bolt, nut, and a new washer
Note:
the bushing in the hole in the groomer drive
assembly.
34. Secure the adjuster-arm assembly rod end to
the groomer drive assembly with a Belleville
washer and locknut
5
1
3
Figure 13
3. Belleville washer
G016229
Figure 14
Make sure that the rod end slides into
(Figure
2
G016217
g016217
(Figure 14).
g016229
(Figure 12).
(Figure 12).
13).