Advertisement
Note:
On multiple passes (i.e., double and triple
cutting), the groomer will continue to penetrate
deeper on each successive pass. Multiple
passes are not recommended.
5. After you test the performance of the groomer
on a test green and obtain satisfactory results,
you can begin grooming on the playing greens.
However, each green may respond differently
to grooming. In addition, growing conditions
are constantly changing. Inspect the groomed
greens frequently and make adjustments to the
grooming procedure as often as necessary.
Transporting the Machine
When you wish to mow without the groomer or need
to transport the machine, raise the grooming reel into
its raised transport position as shown in
Maintenance
Cleaning the Grooming
Reel
Wash off the grooming reel after use. Do not leave the
grooming reel in water or the components will rust.
Greasing the Groomer
Bearings
Lubricate the groomer bearings
27) weekly or after every 10 operating hours, before
extended periods of non use, and immediately after
every washing. Pump grease into fittings until grease
Figure
22.
is purged onto groomer shaft. Wipe excess grease
from the seals and shaft.
Note:
greasing. Disengage cutting unit and wipe excess
grease from the seals and shaft.
11
Operate groomer for 30 seconds after
Figure 26
Figure 27
(Figure 26
and
Figure
G027982
g027982
g010436
Advertisement
