Inspection And Maintenance Schedule - BRP Evinrude E-Tec Series Service Manual

MAINTENANCE

INSPECTION AND MAINTENANCE SCHEDULE

INSPECTION AND MAINTENANCE SCHEDULE
Routine inspection and maintenance is necessary for all mechanized products. Periodic maintenance
contributes to the product's life span. The following chart provides guidelines for outboard inspection and
maintenance to be performed by an authorized Dealer.
Outboards used for rental operations, commercial applications, or other high hour use
IMPORTANT:
applications require more frequent inspections and maintenance. Inspection and maintenance should be
adjusted according to operating conditions and use; and environmental conditions.
SystemCheck self-test and warning horn, check
Emergency stop circuit and lanyard, check operation
Controls, steering and tilting; check operation, lubricate
Engine to transom mounting hardware, re-torque (40 ft. lbs.)
Fasteners, tighten any loosened components
Water intake screens, check condition
Cooling system; check water pump indicator / water pressure
Anticorrosion anodes, check condition
Gearcase, check condition
Propeller, check condition
Fuel and oil system components, inspect and repair leaks
Check battery connections and condition
Access EMM information, resolve any service codes
Electrical and ignition wires, inspect for wear or chafing
Fuel filter, replace
Oil filters, replace
Gearcase lubricant, replace
Spark plugs, inspect or replace
Thermostats, inspect and check operation
Grease fittings, lubricate
Power trim/tilt and fluid level, inspect
Propeller shaft splines, inspect and lubricate
Starter pinion shaft, inspect and lubricate
Control cables, inspect and adjust
Water pump, inspect / replace
(1) Frequency for average recreational use. Commercial use, heavy use or use in salt, brackish or polluted water requires more frequent inspection and
maintenance.
(2) Emission-related component
(3) Annually in salt water applications
A HPF XR Gearcase Lubricant
B Power Trim/Tilt Fluid
C Triple-Guard Grease
D Starter Lube Only P/N 337016
80
Description
(2)
(2)
(3)
(3)
(3)
(more often if water pressure loss or overheating occurs)
Engine
Care
Product
(2)
A
C
B
C
D
Every 300 hours
Routine or every three
(1)
Inspection years