Electrical Harness Connections - BRP Evinrude E-Tec Series Service Manual

INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING

Electrical Harness Connections

Remove flywheel/harness connector cover.
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease
to the seal.
1. Seal
Connect outboard main wire harness to boat wire
harness. Secure connectors in brackets.
1. Harness connections
62
Route oil tank sending unit harness around the
front to the port side. Secure all cables with tie
straps.
004954
1. Low oil sender connection
™
2. Tie straps
Install battery cables on starter solenoid and main
ground stud.
1
1
42079A
1. Positive (+) battery connection
2. Ground (–) connection
Replace flywheel/harness connector cover.
1
004951
1
2
004952
2
004953