JVC KW-M450BT Instruction Manual page 33

Settings Settings
Setting the speakers and crossover
frequency
1
Select a car type ( 1 ), select a speaker
( 2 ) (front speakers, rear speakers, or
subwoofer) to set, then location* and
speaker/tweeter size ( 3 ) of the selected
speaker.
A selection window appears for each setting. Select
an item, then touch [Close] to close the window.
• Repeat steps 2 and 3 to set all speakers.
• Adjustable items vary depending on the selected
speaker type.
• When a speaker is not connected, select [None].
• When setting the front speakers, also select the
speaker size for <Tweeter>.
* Speaker location selection is selectable only when <X'over
Network> is set to [2way].
2
Touch [X'over] to display the <X'over>
screen.
3
Select the speaker type ( 1
the crossover frequency ( 2
selected speaker.
E.g. When <X'over Network> is set to [2way]
• Adjustable items vary depending on the selected
speaker type/speaker size/crossover settings.
• Speaker types shown on the screen differ
depending on the <X'over Network> setting.
<HPF FREQ>
Adjusts the crossover frequency for the front or rear
speakers (high pass filter).
<LPF FREQ>
Adjusts the crossover frequency for the speaker
(low pass filter).
<Slope>
Adjusts the crossover slope.
<Gain>
Adjusts the output volume of the selected speaker.
<TW Gain>
Adjusts the output volume of the tweeter.
<Phase Inversion>
Activates the phase inversion for the speaker.
• To deactivate, touch [Phase Inversion] again.
<Equalizer>
), then adjust
) of the
The following adjustments are memorized for each
source until you adjust the sound again.
Selecting a preset sound mode
1
Display the preset sound modes.
2
Select a preset sound mode.
• Pop/Hip Hop/R&B/Jazz/Classical/Hard Rock/
Flat (Initial)/iPod/User1/User2/User3/User4
To hide the preset sound modes: Touch [ ].
ENGLISH 31