Siemens SIMATIC ET 200SP Manual page 59

stopChargingCurrentInAm-
pere
supportedEnergyTransfer-
Types
Technology module TM ECC PL ST (6FE1242-6TM20-0BB1)
Manual, 07/2019, A5E43919893B-AA
UInt If this value is undershot when the charging process is terminated, the DC
breaker is opened.
This current must be less than or equal to the value of "maxCurrentIn-
Ampere"; otherwise the error message bit 1 (parameterization error) is set.
Word With this parameter you select the energy transfer variants supported by
the charging station
(True = selected; False = not selected).
The designations of the types are taken directly from the DIN SPEC
70121.
Bit 0 = AC_single_phase_core
•
is not supported in DIN SPEC 70121
Bit 1 = AC_three_phase_core
•
is not supported in DIN SPEC 70121
Bit 2 = DC_core
•
DC charging via the pins in the Type1/Type2 connector is supported
Bit 3 = DC_extended
•
Charging via the extended pins of the CCS connector (Type1/Type2) is
supported
Bit 4 = DC_combo_core
•
is not supported in DIN SPEC 70121
Bit 5 = DC_dual
•
is not supported in DIN SPEC 70121
Bit 6 = AC_core1p_DC_extended
•
is not supported in DIN SPEC 70121
Bit 7 = AC_single_DC_core
•
is not supported in DIN SPEC 70121
Bit 8 = AC_single_phase_three_phase_core_DC_extended
•
is not supported in DIN SPEC 70121
Bit 9 = AC_core3p_DC_extended
•
is not supported in DIN SPEC 70121
The DIN_70121 function block only supports DC_core (bit 2) and
DC_extended (bit 3). The error message bit 1 (parameterization error) is
set for all other variants (bit values). In addition, at least one of these two
bits must be set.
The variants supported by the charge column are compared to the variants
required by the vehicle. If the vehicle requires a variant which is not sup-
ported by the charge column, the charge process is aborted.
Programming
5.5 DIN_70121 parameter
57