Commands - Nikon TIRF Instructions Manual

1-7 Commands

(1) c command: Operation, control, and data setting command
c command
cTSO(1)
cTSC
cTTS(2):(3)
cTSW(4)
(2) r command: Data request command
r command
rTSR
rTTS(1)
rTES
rTSW
rVER
IV Shutter Control Unit Communications Commands
1 Communication-controlled operation
o: Normal response
n: Error response
Opens a specified shutter and closes any other shutters. If an
open time period has been specified, the shutter will close
when the specified period elapses. Note that no shutters will
oTSO
open if the eyepiece shutter is open.
nTSO(6)
(1): [1-3] Shutter number
(6): Error code
oTSC
Closes all shutters.
nTSC(6)
Specifies a shutter opening time.
(2): [1-3] Shutter number
oTTS
(3): [0000-1000] Time setting
nTTS(6)
* [0000] indicates no opening time. Unit: 0.1 sec (100.0 sec
max.)
(6): Error code
Enables/disables the laser open/close switch on the control
panel.
oTSW
nTSW(6) (4): [1] Enable, [0] Disable
(6): Error code
a: Normal response
n: Error response
Calling of whether any shutter is open.
aTSR(1)
(1): [0] All shutters closed, [1-3] Number of open shutter
nTSR(6)
(6): Error code
Calling of shutter opening time setting.
(1): [1-3] Shutter number
aTTS(2)
nTTS(6)
(2): [0000-1000] Setting
(6): Error code
Calling of whether the eyepiece shutter is open or closed.
aTES(3)
(3): [1] Open, [0] Closed
nTES(6)
(6): Error code
Calling of whether the laser open/close switch on the control
panel is enabled or disabled.
aTSW(4)
nTSW(6) (4): [1] Enabled, [0] Disabled
(6): Error code
Calling of program version.
aVER(5)
(5): V*.** (five characters with "*" being numbers. Ex.: V1.00)
nVER(6)
(6): Error code
Description of operation
Description of operation
- 32 -