Table of Contents
Advertisement
Chapter 1: Installing the Avaya S8800
Safety instructions
Use the following safety guidelines to ensure your own personal safety and to help protect your
system and working environment from potential damage.
Observe the following precautions for rack stability and safety. Also refer to the rack installation
documentation accompanying the rack for specific caution statements and procedures.
Systems are considered to be components in a rack. Thus, component refers to any system
as well as to various peripherals or supporting hardware.
Danger:
• Before installing systems in a rack, install front and side stabilizers on stand-alone racks
or the front stabilizer on racks that are joined to other racks. Failure to install stabilizers
before installing systems in a rack could cause the rack to tip over, potentially resulting
in bodily injury.
• After installing components in a rack, never pull more than one component out of the
rack on its slide assemblies at one time. The weight of more than one extended
component could cause the rack to tip over and may result in serious injury.
• Use caution when pressing the component rail release latches and sliding a component
into or out of a rack because the slide rails can pinch your fingers.
Note:
• Your system is safety-certified as a free-standing unit and as a component for use in a
rack cabinet using the customer rack kit. It is your responsibility to ensure that the final
combination of system and rack complies with all applicable safety standards and local
electric code requirements.
• System rack kits are intended to be installed in a rack by trained service technicians.
Important:
• Always load the rack from the bottom up, and load the heaviest item in the rack first.
• Make sure that the rack is level and stable before extending a component from the rack.
Installing the Avaya S8800 Server for Avaya Aura
Server
Collaboration Server
®
December 2010
13
Advertisement
Table of Contents
