7 Power supply system SITOP PSU8600
Setting the SITOP PSU8600 parameters (commissioning)
In the HW configuration for the PSU8600, you can set general parameters,
parameters for PROFIenergy and the output parameters of the basic module's and
the expansion module's 24 V outputs.
You can find more detailed information on the different parameters in the
SITOP PSU8600 manual.
The procedure is as follows:
1. Select the PSU8600 (1) in the hardware configuration.
2. Open the properties of the "PSU8600 3ph" module (2) on slot 0.1 by double-
clicking.
3. Switch to the "Parameters" tab and set the parameters (3) as desired.
4. Open the properties of the 24 V outputs one after the other (4) and set the
parameters of the outputs as desired.
5. Compile and load the hardware configuration.
Fig. 7-4
Integration of a SITOP 24 V Power Supply in PCS 7
Entry ID: 109481908,
V1.0,
2
4
04/2016
1
3
51